How to DIY Cute Women's Wrap Pants

Tools and materials:

• Linen fabric (100x100cm)
• Ruler
• Tailor’s chalk
• Scissors
• Plate
• Pins
• Sewing machine with a serger

1. Mark the fabric

Fold your fabric in half lengthwise and then in half again so you have two folds.

On the two folds, measure and mark 13cm from the bottom on the vertical line. On the horizontal line, mark 25cm in from the corner.

2. Connect the points and cut

Draw a curve that connects these two points. The curve will measure 32cm (12.6 inches). Proceed to cut along this line.

3. Mark the opposite corner

The remaining length line at the bottom should measure 75cm. Cut off any excess fabric.

Mark 15cm down from the top as well as 15cm in from the side in the opposite corner from where you cut before.

4. Draw a curved line and cut

Place and plate in the corner and draw around the edge to connect the two points with a curved line. Then cut along this line.

5. Sew the curved section

Open up the fabric and place the two right sides together.

Sew around the large curved section with a zigzag stitch on a sewing machine with a serger.

6. Fold in the sides and sew

Fold the top layer of the side in by about an inch and pin it in place as shown. Do this all around the pants.

Repeat on the other side of the pants and then proceed to sew the rolled hems down.

7. Open up the pants

Open up the pants by holding the two parts on either side together, as shown.

8. Cut strips of fabric

Cut two strips of fabric that measure 160x8cm (63x3 inches). 

9. Pin the fabric to the pants

Find the center of the loop and pin it to the center of the pants on the wrong side.

Continue to pin all the way around and sew. Then repeat on the other side of the pants.

10. Fold the band down

Turn the pants right side up. Fold the strip of fabric down twice and pin it to the top of the pants.

11. Pin the sides

With the remaining fabric at the sides, fold the end in and pin it down to hem it.

Fold each long side in by about 1cm (0.4 inches), then fold the band in half and pin it down.

Repeat this process for the rest of the band on both sides of the pants.

12. Sew

Finish the pants off by sewing the band down all around.

DIY women’s wrap pants

And now the pants are complete. They are such a unique design and are a real showstopper piece.

Thanks for following along with this DIY simple wrap pants tutorial. I hope you’ll give them a go for yourself!

If you do, leave a comment. And, for more sewing content, check out my post on How to DIY a Versatile Scarf Top.